HOW TO GET FLOORING & WALL PRODUCTS APPROVED

Our Technical team is constantly updating this list, so please check back often. If you have a floor or wall product that you would like us to test on our range of adhesives, please follow instructions below.

If Spray-Lock is right for your needs, testing can begin. Send samples of your product to Spray-Lock, and allow three business days from receipt of materials for testing to be completed. Please include:

• Samples of Flooring

Sheet Goods: A minimum of four (4) square feet with at least one factory edge, product can be rolled for shipping. Product can be rolled for shipping. If possible, a sample that is the full width of the roll is recommended.

LVT and Carpet Tile Products: A minimum of two (2) full tiles, regardless of size format, shipped flat. If possible, a full box of tile is helpful in case extra testing is needed.

• Samples of Wall Panels and Coverings

For General Bond Only: At least one (1) full-size panel if the product is a large format (i.e. 4×8 ft or similar), and at least four (4) square feet if the product is smaller format (i.e. wall tile, mosaic, etc.)

For General Bond and Dimensional Stability: At least two (2) full-size panels if the product is a large format, and at least twelve (12) square feet if the product is a smaller format. If possible, for smaller formats, a full box of tile is helpful in case extra testing is needed.

• Tech Data Sheet for materials to be tested (if applicable, include the manufacturer’s preferred method of installation)

• Contact Info: Name, phone number and email address

Spray-Lock will contact you upon receipt of materials and then with the results.

General Bond testing will take three business days (from receipt of materials) to complete.

Dimensional Stability testing will take up to seven business days to complete.

Plasticizer Testing, if needed, will require three weeks for completion.

Ship materials to:

Spray-Lock, Inc.
ATTN: TESTING
5959 Shallowford Road
Suite 405
Chattanooga, TN 37421